Adaptacus Use

How to use Adaptacus

The Adaptacus can be used to manually feed any width and depth tapes, side by side on a single run in any order.

Click the projector image to download a video showing the simple assembly of Adaptacus (20Mb).

Click here to download a PowerPoint presentation showing the simple assembly of Adaptacus (1Mb).

Click here to download a PowerPoint presentation showing how to change reels (1Mb).

How to assemble Adaptacus
	Slide the block between the upper and lower thin rails. Blocks are colour-coded to show thickness of tape: Brown = 1mm Red = 2mm Orange = 3mm Yellow = 4mm Green = 5mm Extra pip adds 0.5mm to thickness
	Slide the tape between the upper and lower thin rails, on top of the block.
	Weave the tape plastic over, under and over the top thin rails.
	Slide the next divider up against the block.
	Place the pcb anywhere on the work area, near the components you are about to place...
	...even over the other tapes, if it makes it easier.
	Tapes of varying sizes placed next to each other in any order.


Lift the spindle towards you...	...slide the spindle down into the lower position...	...the reels rest on the bottom supports.